Boiler Repair BRIDGEND

Boiler showing a fault code? What to do first

Updated 1 October 2026 · 2 minute read

A boiler that has locked out with a code on the display is telling you something specific. The worst thing you can do is clear it without writing it down. Here is the order we would ask you to do things in, before you ring us or anyone else for a boiler repair in Bridgend.

Step one: photograph the display

Before you touch anything, take a photo of the code and the screen. Resetting the boiler wipes the code, and the code is the most useful thing you own when you call an engineer. It narrows the fault quickly and often tells us which part to bring, so the repair happens on the first visit instead of the second.

Step two: three quick checks

These cover a surprising share of lockouts, and none of them need tools.

  1. Pressure. The gauge on the front should read between 1 and 1.5 bar when the system is cold. Under about 1 bar and the boiler will lock out on low pressure, and no amount of resetting will fix it until you top it up on the filling loop.
  2. Gas and power. Check another gas appliance lights, and check the fused spur next to the boiler and the consumer unit. It sounds obvious, and it is genuinely one of the common reasons engineers get called out to a boiler that is not broken.
  3. The weather. If it has stopped in a frost and is gurgling, the condensate pipe outside has probably frozen. That has its own fix, covered in our guide to frozen condensate pipes.

Step three: reset once

On most modern combis the reset is a button or a dial position marked with a flame or the word reset. Hold it for about three seconds, let go, and give it two or three minutes. The boiler will purge and try to fire.

What happened next?

  • It fired and stayed on. Note the date and the code. If it happens again within a few weeks, tell an engineer, because an intermittent fault caught early is usually cheaper than one caught late.
  • It fired, then locked out again within the hour. Stop. That is a real fault, and every reset is another ignition attempt on a boiler shutting down for a reason. Note the code and how long it ran before failing.
  • It will not light at all. Recheck the pressure and the gas. If both are fine, it needs looking at.

Stop and call if

  • You smell gas. Call the National Gas Emergency line free on 0800 111 999 before anything else.
  • There is water inside the case. Turn it off at the spur.
  • There are black or sooty marks around the boiler or the flue.

Never take the case off. Anything behind it is Gas Safe work, and opening it can void the warranty.

Sending us the code

Message us the make, the code and how long it ran before locking out. With those three, we can usually tell you the likely cause and what the visit costs before anyone sets off. Book a boiler repair.

Book a boiler repair in Bridgend

Leave your details and what the boiler is doing. We come back to you with what the visit costs before anyone sets off.

  • Gas Safe registered engineers
  • Repair priced before any work starts
  • 1 year warranty on our work

Tell us about the breakdown

Takes under a minute.

You will know what the visit costs before we set off. We only use your details to arrange your repair. Or call 07712 646488

Smell gas? That is an emergency, not a booking. Call the National Gas Emergency line free on 0800 111 999, open the windows and leave the switches alone.

Call 07712 646488 Book a repair